s2000Junky

This likely wouldn’t work very well due to the short run between the blower and Aftercooler if it could be done at all. The VT CT SOS all have a different shape aftercooler and offset and therefore distance/alignment to blower, but if one of them could work, the coupler angle would surely be a severe 90 degree on both ends, and you would lose some efficiency for sure. If the Rotrex wont clock in the right direction with the outlet volute on the bottom, then it may not be worth the attempt.

michaelnyden

Can anyone confirm if it will clock facing the bottom?

Moddiction

According to diagram from rotrex it will but at a 120 degree angle.

06S2k07Si

On the TTS kit the blower is too far to the driver9s side to fit the SOS cooler in there.

If you were making one you could just keep the blower in the same position and use a 180 deg off the blower output (its 2.5") and under the intake, then back to the TB. Maybe fab one in a similar fashion to an SOS piece.

michaelnyden

I was thinking the SOS aftercooler design is ideal...I believe piping can be made to work with the blower output at 120 degrees.

Moddiction

On their site it says 120 degrees however looking at the blower I don't see how that is possible. It would need to be counter clockwise to come out to the right on the bottom. From looking at installed images it would be coming out on top.

Moddiction

Here is the rotrex diagram.

Moddiction

Here is a C38 installed.

michaelnyden

I wonder if a 180 degree bend tube would work?

06S2k07Si

Maybe... But the SOS cooler is too wide as it is to fit in between the blower and the TB without major modifications.