Dash cutting club
01-19-2005, 02:38 PM
#51
Registered User
Join Date: Mar 2004
Location: minnetonka
Posts: 85
Likes: 0
Received 0 Likes
on
0 Posts
thats pretty fricken sweet. haha what are the chances i work at ultimate electronice in minnesota, i never even thought they could do dash stuff like that haha.
03-19-2005, 07:07 AM
#57
How is everyones hole holding up? In terms of the pull of the vinyl, etc around the mold? Mine looks pretty good..I notice a tiny sagging of the frame..I think I can get behind it and tighten the sucker!
03-19-2005, 07:18 AM
#58
Registered User
Join Date: May 2003
Location: Yardley PA
Posts: 1,709
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by mikes2k,Mar 19 2005, 11:07 AM
How is everyones hole holding up? In terms of the pull of the vinyl, etc around the mold? Mine looks pretty good..I notice a tiny sagging of the frame..I think I can get behind it and tighten the sucker!
03-19-2005, 07:43 AM
#59
Originally Posted by YELOSCREAMER,Mar 19 2005, 11:18 AM
Nothing on my end yet.....But then again I'm what, almost a year behind you on install date?
club 
03-19-2005, 11:50 AM
#60
Registered User
Join Date: Aug 2004
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
personally i liked the thinner look myself. however the edges were starting to tear just a little bit so we had to do some slight cutting and the result was we needed a lip around the outside. Next version of the frame is going to be a little better with a raised bevel and smaller lip.