Lower rear fender extension bent... Replacing?
#1
Registered User
Thread Starter
Join Date: Nov 2012
Location: Inland Empire, Southern California
Posts: 37
Likes: 0
Received 0 Likes
on
0 Posts
Lower rear fender extension bent... Replacing?
Hi guys,
Due to a parking lot accident, my rear bumper was replaced by the previous owner. I just recently found out that the lower rear fender (As Majestic Honda calls it, parts 9, 13, 36, and 38) is bent. This is the area where the lower screw for the rear bumper goes in. Due to this, my bumper fitment is a little off and more importantly I am afraid that this might affect my car in the handling department (Nothing out of the ordinary when I'm driving the car however).
Has anyone replaced this part before? If so, what did you have to do? I haven't gotten a chance to go under the car yet so I'm not sure how the part is attached on the car.
Thank you in advance.
Due to a parking lot accident, my rear bumper was replaced by the previous owner. I just recently found out that the lower rear fender (As Majestic Honda calls it, parts 9, 13, 36, and 38) is bent. This is the area where the lower screw for the rear bumper goes in. Due to this, my bumper fitment is a little off and more importantly I am afraid that this might affect my car in the handling department (Nothing out of the ordinary when I'm driving the car however).
Has anyone replaced this part before? If so, what did you have to do? I haven't gotten a chance to go under the car yet so I'm not sure how the part is attached on the car.
Thank you in advance.
Thread
Thread Starter
Forum
Replies
Last Post