Mark this thread as Sold
FS- Triple Adj JRZ Motorsports Edition Shocks
#1
Registered User
Thread Starter
Join Date: Jun 2009
Location: Frankfort, KY
Posts: 4,340
Likes: 0
Received 0 Likes
on
0 Posts
FS- Triple Adj JRZ Motorsports Edition Shocks
Triple Adj JRZ Motorsports Edition shocks and have been shortened for STR type ride heights. ($1400 modification) I run my car at 13" from wheel center to fender but I've had it as low as 12" with no rubbing issues. Theses are the motorsport version which is more expensive then the RS and the RS Pro versions. They also have quick disconnects on every shock which is a $250 per shock modification. These shocks new go for $8000+.
(the front canisters had some heat shield stuff wrapped around it and I took it off. The canisters need to be cleaned with goo-gone to get the sticky off.
Shortened rears-
Shock dyno- (I have probably 7-8 more of different settings)
Shocks come with everything you see pictured. The hypercoil springs are 900F/800R.
$4500.00 or best offer
PS- If these sale, I'll have a huge part out thread soon after for the rest of the parts on the car.
(the front canisters had some heat shield stuff wrapped around it and I took it off. The canisters need to be cleaned with goo-gone to get the sticky off.
Shortened rears-
Shock dyno- (I have probably 7-8 more of different settings)
Shocks come with everything you see pictured. The hypercoil springs are 900F/800R.
$4500.00 or best offer
PS- If these sale, I'll have a huge part out thread soon after for the rest of the parts on the car.
#4
Registered User
Thread Starter
Join Date: Jun 2009
Location: Frankfort, KY
Posts: 4,340
Likes: 0
Received 0 Likes
on
0 Posts
No they actually pass the one inch rule. (barley!) but in RTR you can't run triples. So I rather sell them and buy doubles then weld the adjusters together on a $8000 set of shocks. :/
I can get the standard length bodies from the shock builder if the buyer wants them. I think it would cost about $400 in labor to switch the bodies back over to standard length though. Most people will want them this size...
If they don't sell by April 1st ill be staying in STR and putting them on that car.
.... Funny how you knew exactly what I'm doing though!
I can get the standard length bodies from the shock builder if the buyer wants them. I think it would cost about $400 in labor to switch the bodies back over to standard length though. Most people will want them this size...
If they don't sell by April 1st ill be staying in STR and putting them on that car.
.... Funny how you knew exactly what I'm doing though!
#5
yes you can! remove one knob! As long as you can only change two settings between runs, you've made the shock double adjustable. dead serious by the way.
btw, you already said you wanted to do this in the BSP thread.
btw, you already said you wanted to do this in the BSP thread.
#7
Registered User
Thread Starter
Join Date: Jun 2009
Location: Frankfort, KY
Posts: 4,340
Likes: 0
Received 0 Likes
on
0 Posts
I'm not sure why my new listing got deleted, I copied the pictures from this original post and reported it, I guess I should of just rebumped this thread. I lowered the price quiet a bit. They are now for sell for $4500 or best offer.
Trending Topics
#10
Not going to PM everyone who doesn't read good and can't follow instructions.
I'll leave this thread open until tomorrow so Josh can reformat the first post. Otherwise it gets locked too.