VOLTEX GT-Wing / Aero Thread!
#861
I would start by mounting the trunk mounts first, then fit the wing. There should be a little tension, but not so much that the dry carbon legs on the wing are stressed.
You are however missing a piece. Most Voltex wings have a long slender portion that mounts to the trunk. Look at the second picture, it's small but you can see it here:
#862
Member
Yep I have those
I was just using the stands to mark the holes on the trunk (until I found it was too wide!) Those rubber / plastic bits actually make my problem a tiny bit worse as they sick out further than the screw holes. I'm pretty sure they have made a dimension error on this wing
I was just using the stands to mark the holes on the trunk (until I found it was too wide!) Those rubber / plastic bits actually make my problem a tiny bit worse as they sick out further than the screw holes. I'm pretty sure they have made a dimension error on this wing
#863
Yep I have those
I was just using the stands to mark the holes on the trunk (until I found it was too wide!) Those rubber / plastic bits actually make my problem a tiny bit worse as they sick out further than the screw holes. I'm pretty sure they have made a dimension error on this wing
I was just using the stands to mark the holes on the trunk (until I found it was too wide!) Those rubber / plastic bits actually make my problem a tiny bit worse as they sick out further than the screw holes. I'm pretty sure they have made a dimension error on this wing
It's hard for me to tell from the picture, but again, my wing requires a bit of tension to mount