VOLTEX GT-Wing / Aero Thread!
#851
Originally Posted by EvasiveMotorsports,Feb 24 2011, 05:10 PM
JUST IN:
Voltex S2000 kit is scheduled for a wind tunnel test in May!
Voltex S2000 kit is scheduled for a wind tunnel test in May!
#853
Member
Hoping for some fitting advice! I have just got a new Ings wing and fully assembled it and tightened everything up, but when I offer it up to the boot / trunk lid, the mounting brackets are sitting just a bit further out than the edge of the lid. Are you supposed to bolt the mounting stands to the lid first then make the wing fit onto them?
The only other thing I can do is switch the lugs so they are facing inwards.
The only other thing I can do is switch the lugs so they are facing inwards.
#857
Member
Thanks guys. If I put the risers on the outside it's going to make it even wider though. At the moment it doesn't fit on my lid, unless I point the 4 mounting lugs inwards...?!
#859
#860
Member
That's how I have it at the moment then? Stands on the inside / wing risers on the outside. The only way I can make this fit is turning the lugs inwards