NFR_AP2

sold

http://www.flickr.com/photos/usdmej6/5898902075/

illdiealonlyazn

I dont understand how you guys can run front spacers and not rub fender without modding it. I'm not running any spacers with 225 RS3's and I rub the fender tabs under cornering. Lowered to probably about 1.5 finger gap and 1.5 degree camber in front.

dirtykoala

ill have pics up later, heres an update though.

i just got 255s on the rear and 225s up front. with no gap, 25mm spacers and -3.3 camber, im rubbing slightly on the tip of my bumper. ill probably try to pull the bumper a little and maybe cut it a little

dirtykoala

strange - after about 20 miles of driving i am not rubbing anymore.

NFR_AP2

can 10mm spacers fit on ap2v2 wheels? i mean will the recess in the wheels be enough to compensate for the exposed stud?

dirtykoala

here are some pics with my new tires on. Sorry for the poor quality, ill be taking better pictures soon, these are just with my point and shoot in bad lighting

spacers - 25mm rear, 20mm front
tires - 255/40/17 rear and, 225/45/17 front
finger gap - none

Alignment specs:
Front:
Camber - -2.0
Caster - +6.5
Toe - 0.00

Rear:
Camber - -3.3
Toe - +.05 (.10 total)

k1ng124

liquidtek

NFR_AP2

just bought 20mm spacers for the rears. do any of you know if 10mm bolt on spacers will work with the recessed holes in oem ap2 wheels? (this is for the front)

OvaDaLimiT

it depends what version of the 10mm spacer you buy. Some come with specialty flat nuts so the stock studs won't be as large. My 16mm was like this.
As for whether the OEM wheels can fit the entirety of the stud (-10mm), you could probably measure the length of the stud and the wheel recess and see?