jdmartinez

My Nardi Orido Style

SeanSerino

How did you wire the horn? I can't get mine to work with my NRG short hub, 2.5 QR, and Momo Tuner.

S2KWALT

i just wired it up to the black wires on the quick release. plugged the male connector on the quick release into the female connector that is on the cable reel, then the female connector that is on the quick release to the horn button

SgtDuracell

On the NRG short hub you should have the disc at the back with electrical grease. chop the horn wire and wrap it around a screw and make sure it is in contact with the back on the hub (the part with the electrical grease) the rest is just connecting the wires that are on the center of the hub to the center of the quick release and connecting the horn button. once you pull your wheel off with the quick release there are two metal dots on the hub side of the quick release. touch metal in between them and you should hear your horn. if not then check the wire at the back that you chopped. if you do hear it and it doesn't work when you put the wheel on... check your horn wiring. its pretty straight forward.

hope that helps

Killin9's

here is mine, momo tuner 340mm with NRG quick release and hub. Authentic NSX-R horn button.

red@9k

^^^looks good. I have the same setup but with a WB hub. IMO i would ditch the ring. It's overwhelming the steering wheel. Just using the horn button alone would look so much better.

volkdc2

^^^ that's the way I have it...with no horn ring. Stays on just fine and looks cleaner

SgtDuracell

my wheel. more of a sentimental thing as well as it used to belong to a very good friend of mine that passed away..

hdoan112

my momo tuner 320mm with nrg quick release and short hub

http://www.flickr.com/photos/hdoanphotos/6576500291/http://www.flickr.com/photos/hdoanphotos/6576500291/ by http://www.flickr.com/people/hdoanphotos/, on Flickr

Killin9's

thanks man, yeah maybe I should get rid of it. I agree with you about it over powering the whole thing.