Official Flush/hella flush(STANCE FTW) S2 THREAD
11-19-2014, 10:21 PM
Registered User
11-19-2014, 10:23 PM
Registered User
12-13-2014, 06:07 PM
Originally Posted by profitable' timestamp='1308673351' post='20704595
What do you guys do about your pinch welds ??? Are you worried about them at all ? should i be ? 
I do my best to avoid things taller than 2.5" When I go over them, my seam welds let me know "scraaaaaape!"
Is there any thing wrong with kinda bending the seam welds in just the center of each side to alleviate this problem? The car's front clears my garage and speed bumps just fine but there is a little lip at the entrance of the garage that it definitely scrapes on... its more of an issue of the angle that my driveway meets the garage than the car being 'too low' would it be a bad idea to bend in the centers just a bit to help gain some clearance? Those things come down a good inch past the body... I'd only need to bend like a 12" piece of the middle... not the whole thing and no where near the jacking points...
thoughts?
12-14-2014, 08:15 PM
Registered User
Join Date: May 2014
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
12-31-2014, 04:33 AM
Join Date: Oct 2014
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
12-31-2014, 08:00 AM
Raises the trunk to fill car with gas?
Looks nice, but I drive my car way too much to run that much camber.
Smooth looking ride though.
Front facia? I like OEM AP1 more.
No third brake light kills it for me, nice blending of the tail section though.
Thanks for sharing.
Looks nice, but I drive my car way too much to run that much camber.
Smooth looking ride though.
Front facia? I like OEM AP1 more.
No third brake light kills it for me, nice blending of the tail section though.
Thanks for sharing.