chrisaltima

Proud owner since 2013...at 9.5" and 16.2 lbs. I find them hard to let go.

fat_tee

That looks lush mate
What are the specs on that please

Akkmednoseflem

Untitled by Akkmed, on Flickr

Dreaming_S2k

I miss you guys.

Jhoang

I've been reading this thread for hours and i can't seem to get clear answer
So basically I'm in the market for some rpf1's and I'm really set on the 17x9 +45 look of the wheel
I'm lowered on coilovers and i have about a 1finger tip gap for the front and 2 in the back
My tire sizes are Front: 215/4517, Rear: 255/40/17

So what my question is what tire size should i run in the front for a 17x9 +45? 245/40 or 255/40?
I don't really want to have to pull my fenders or run any more than -2 degrees of camber and i just want a flush fitment.
i already have my fenders rolled with a tab relocation and I'm set with a 255 in the rear.

if you guys have any advice please let me know i would greatly appreciate i!

riceball777

My custom 17x11.5 rof1 with 295/35/17 jumbo xs tires

Dreaming_S2k

I'd highly suggest just running 245/40 all around, given your requirements.

fernando.

Yeahhh if you don't want to pull or run more than -2 degerees, you should stick to a 245/40 or even a 235/40.

I'm 255/40 with a slight pull, less than 1 finger gap and around -2.8ish.


35mm by fernando.k, on Flickr

fastb4ck

So far I've seen

17x9+45 with 255's all around with just roll and tab relocation

and I've seen

You need to pull with the same set up

lol

Ap2low

You will be fine with just a roll and tab relocation, you will be better with a slight pull.

Here is mine before I had the fenders slightly pulled :