bloose117

so sick

EriS2k

Teh Sex!

DR. FEINSTONE

Do you still have function of the passenger air bag? I know that ap2 2006+ have the air bag sensor built into the stock seat rail and the hump is different. Do you modify the buddy club seat rail to fit the existing nut and bolt ome mount? Or you drill new holes to mount the buddy club rail. Does it have a lower seating height compare to the ome seat rail? Thanks

ssms2k

i have buddy clubs on my spg fitment is no problem...only problem i have with the recaro is the shoulder bolster rubs on my glove box when putting it up and down but no worries!

s2kologist

recaro pole position on bride ro with recaro side mounts.





the seat belt latch does not fit too well. i made a bracket to extend the height of the latch but that caused problems. when the latch was at the right height it would be so smashed by the seat/center console that it would jam. so i took out the bracket and the latch sits too low to reach. what i have to do is stick my key in between the center console and seat to press the button to release the seat belt. it has not annoyed me too much yet. i dont know if if is more annoying to use the key method or to get a harness.

I tried using mugen rails with my PP. It did not work. they did not fit right. the slider rubs the seat and prevents the seat from sliding. the only way to bolt the seat to the mugen rail is to use the highest mounting points. when mounted to the seat the rails sit too wide to bolt in to the car. that was with the bracket against the seat and the spacer on the outside of the that.

The seat work ok on the bride rails with recaro side mounts. in the rear you have to use the highest mounting point. in the front you can use any mounting point. i used the lowest. the seat clears the center console and door with no problem. the seat fells very slightly higher than stock.

FiLi

So for the Recaro PP or SPG, the taitec rails are the lowest (in terms of driving position) in the market?

And about Bride Rails, what model is the best for those Recaro that i mentioned above?

Thanks in advance.

s2kologist

if you use bride RO rails for recaros you need to use the recaro side mounts.

mikey k

Which adds height
I'm on the hunt for a set of Pole Positions to go on Taitec rails

s2kologist

the pole position is a really wide seat. it did not fit on mugen rails. i dont know if it will fit on taitec. there are some people using buddy club rails, i dont know if they are any lower though.

sspicollo8

Recaro SPA. leg bolsters much larger than the SPG, shoulder bolsters slightly wider. anyone that fits in an SPG should fit in an SPA though, unless you're the master of the leg press and have some monster thighs.




This is BARELY noticeable in person, just wanted to show a pic. Could have left it alone and let it rub a little, but my friend has had his SPG for a while and the rubbing has worn a small hole through the seat cover. $30 to replace the panel from honda or $400+ to replace the seat cover from recaro... zero rubbing now, including the glove box door.