OK - so I f'd up...
#1
Thread Starter
OK - so I f'd up... - F'd UP NO MORE!!
Gents, so I bought a beautiful set of Regamaster Evo's in Bright II - my grail wheels. But after test fitting them I came to realize that the offset is just too low. Being 17x8 +38 in front and 17x9.5 +45 in the rear, they stick out approx 1/2" past the fenders - and thats w/o any tires mounted. I can't return them, so it looks like I need to have the fenders rolled & pulled. That stated, can anyone recommend a person or a well-regarded shop in the NY metro area that does this kind of work?
Thanks in advance for any advice.
Thanks in advance for any advice.
Last edited by RexRacerX; 07-12-2024 at 10:42 AM. Reason: Updated
#2
Machine them ?
#4
Depends on the construction=machine shop & engineer
#5
S~Factor in PA
Roll, pull or cut. Your choice. Best fabricator in the East coast community. S2000 former owner and NYMETRO member. You can see his work on Instagram. Tell him Al sent you.
You will thank me later.
Roll, pull or cut. Your choice. Best fabricator in the East coast community. S2000 former owner and NYMETRO member. You can see his work on Instagram. Tell him Al sent you.
You will thank me later.
Last edited by Langelo DeMysterioso; 05-31-2024 at 04:38 PM.