Need to remove hub -- need ball joint remover
#11
Thread Starter
Originally Posted by Billman250,Dec 11 2008, 09:20 PM
Tie rod puller on the left...perfect for s2k lower ball...
To sum a long story up, my wheel bearing is shot so I'm getting it replaced so both upper and lower ball joints must be popped.
#13
I believe the upper arm is pressed into the hub, although you can carefully remove it with a hammer. I would just remove the arm with the hub and bring the entire assy to get the bearing replaced. If you do separate the upper arm from the hub make sure you notice the marking for alignment, its small arrow if i recall.
#14
Thread Starter
In picture 5 and 6 you can see the ball joint is not pressed in or anything...that little L backet might be but I'm not concerned about removing that.
https://www.s2ki.com/forums/index.php?showtopic=223599
https://www.s2ki.com/forums/index.php?showtopic=223599
Thread
Thread Starter
Forum
Replies
Last Post
erickss13
S2000 Under The Hood
6
11-25-2010 05:11 AM
kMfromLA
S2000 Under The Hood
36
09-06-2004 09:34 AM