Mark this thread as Sold
Widenned AP1 Rear Wheels! 16x8.5!
#1
Thread Starter
Widenned AP1 Rear Wheels! 16x8.5!
I have 2 AP1 rear wheels widenned by weldcraft wheels by an inch to 8.5".
They are in fair condition I soaped them down but could use a proper polish.
To duplicate these would cost over $400 asking $350 shipped.
I should add offset is over +70 you need to run a 5mm spacer to clear the A-arm.
I ran a 25mm studded spacer and it fit.
Also have AP1 rears you can use for the front, $50 each + shipping
They are in fair condition I soaped them down but could use a proper polish.
To duplicate these would cost over $400 asking $350 shipped.
I should add offset is over +70 you need to run a 5mm spacer to clear the A-arm.
I ran a 25mm studded spacer and it fit.
Also have AP1 rears you can use for the front, $50 each + shipping
#5
I had my 9.5 RPF1's widened to 11.5" by Weldcraft. I can vouch for their awesome craftsmanship. Funny I though about doing this years ago with my ap1 wheels
Tip for quick sale - Try posting these up in my Pacific NW forum as there is allot of track junkies that may want these.
Tip for quick sale - Try posting these up in my Pacific NW forum as there is allot of track junkies that may want these.
Trending Topics
#8
Thread Starter
I ran them on the track, they are true and balance fine.
I have run 205 Hoosier R6, 225 Hoosier R3S04's, 225 Avon Tech-R's and 245 Ra1's on these.
Street tire wise you could run a wide 225 or a 245 or even a 265, I think Kuhmo make a 265 MX tire.
I have run 205 Hoosier R6, 225 Hoosier R3S04's, 225 Avon Tech-R's and 245 Ra1's on these.
Street tire wise you could run a wide 225 or a 245 or even a 265, I think Kuhmo make a 265 MX tire.
Thread
Thread Starter
Forum
Replies
Last Post
601WHPS2K
Forced Induction For Sale
0
03-31-2011 07:56 PM