When you click on links to various merchants on this site and make a purchase, this can result in this site earning a commission. Affiliate programs and affiliations include, but are not limited to, the eBay Partner Network.
I have a couple sample engraved shift knobs laying around I do not need anymore.
1 was a good size engraving but not deep enough for my liking. It does not really go deep at all, just removed some of the surface area for the engraving.
This is shift knob #1
Shift knob #1 is sold!! Thank you.
Shift knob #2
Is plenty deep just smaller of engraving than I was looking for. It is done by the same engraver that is doing my ones for my Pre-Order I have going as well.
Can check that out here. https://www.s2ki.com/forums/index.ph...f=187&t=790020
They were just able to make it larger.
Still looks really nice and very precise engraving!!
These both are in very nice condition, with possibly some very slight surface scuffs. Nothing you can even feel just in certain light might see a VERY slight rub mark or something.
Both are very close to perfect condition.
Price is $55 shipped to anywhere in the US via USPS.
how countersunk do these sit on the stick compared to the voodoo knobs? I've been wanting to get my voodoo engraved but I know yours are a bit heavier since they're steel instead of Al, but if this sits the same I would be interested. Thanks
Well being engraved you need to position it to have the pattern straight. So might be a turn or so higher than how it normally would sit. Without using the height adjustable feature these use it will sit as low or lower than a voodoo knob. It would sit as low as a 2" shift knob can possibly sit.
For the engraved ones I supply 2 nuts and a lock washer. You tighten the nuts against each other on the shift lever, put the lock washer on top and then tighten the shift knob down, if the engraving is crooked just slightly adjust the height of the nuts and screw shift knob back down. Takes a couple tries and then will get it straight. Easiest height adjustment feature I have used that allows it to sit nice and low still.
Originally Posted by khangoc,May 22 2010, 08:29 AM
how countersunk do these sit on the stick compared to the voodoo knobs? I've been wanting to get my voodoo engraved but I know yours are a bit heavier since they're steel instead of Al, but if this sits the same I would be interested. Thanks
You know how voodoo knobs have that little nub off the bottom of the knob it self... The moddicition knob is totally round and the bottom of that sits where the bottom of the nub is on voodoo, So moddiction knobs actually sit a little lower than voodoo. But his new ones are also adjustable so could be same or lower than voodoo which ever you like.
You know how voodoo knobs have that little nub off the bottom of the knob it self... The moddicition knob is totally round and the bottom of that sits where the bottom of the nub is on voodoo, So moddiction knobs actually sit a little lower than voodoo. But his new ones are also adjustable so could be same or lower than voodoo which ever you like.
Cool beans! That bolt system is how my skunk 2 knob is on my civic. I'm in for knob 2 if still available.
05-21-2010, 01:03 PM
Moddiction Sample engraved shift knobs for sale.
