Mark this thread as Sold
Laskey Racing Fully Built Motor
#1
Registered User
Thread Starter
Join Date: Feb 2005
Posts: 1,815
Likes: 0
Received 0 Likes
on
0 Posts
Laskey Racing Fully Built Motor
I am looking to trade my fully built Laskey motor and it only has 986 miles to date! The motor is barely broken in and I didn't even do a full out high horsepower tune. The car was driven on 9psi with 365WHP and had no issues at all!
I purchased the motor for $4300 shipped which included:
Benson Sleeves
CP Pistons on Manley Rods
Supertech ValveTrain
Portflow Valvejob
I am looking primarily for a trade, but if the price is right I will sell as well! AGAIN I AM IN NO NEED TO SELL AND AM NOT DYING FOR MONEY. If I don't sell I will keep the motor for a later project. PM me if you have any questions and again would like to tell everyone I am a HIGHLY trusted seller on s2ki.
Trade only for AP1/2 low mileage motors!
$2300 + Stock low mile AP1/2 shortblock (less than 40,000 miles).. NOW $2000
or
$4100 Shipped.... NOW $3900 SHIPPED!
Some videos:
http://www.youtube.com/user/jdanie7
http://www.youtube.com/user/jdanie7#p/a/u/1/OsI-7hNT4JA
JD
I purchased the motor for $4300 shipped which included:
Benson Sleeves
CP Pistons on Manley Rods
Supertech ValveTrain
Portflow Valvejob
I am looking primarily for a trade, but if the price is right I will sell as well! AGAIN I AM IN NO NEED TO SELL AND AM NOT DYING FOR MONEY. If I don't sell I will keep the motor for a later project. PM me if you have any questions and again would like to tell everyone I am a HIGHLY trusted seller on s2ki.
Trade only for AP1/2 low mileage motors!
$2300 + Stock low mile AP1/2 shortblock (less than 40,000 miles).. NOW $2000
or
$4100 Shipped.... NOW $3900 SHIPPED!
Some videos:
http://www.youtube.com/user/jdanie7
http://www.youtube.com/user/jdanie7#p/a/u/1/OsI-7hNT4JA
JD
#5
Registered User
Thread Starter
Join Date: Feb 2005
Posts: 1,815
Likes: 0
Received 0 Likes
on
0 Posts
I don't want a different motor, as I stated I am going back to stock! My orginal AP2 motor is the one I sent to get built which I am selling. I am not going to have a turbo in the car anymore so a 9:1 compression built block will be slow as SHIT if that makes sense. So since all parts are coming off I need a stock motor to drive on.
JD
JD
Trending Topics
#10
dashboard lights will work but your tach won't go high enough...i'm using a ap1 cluster with ap2 motor and before I got my aem ems I was using the ap1 ecu to run the ap2...works fine...you'd have to get a dif cluster and ecu