Mark this thread as Sold
FS: Ap1 Motor Partout
03-24-2011, 04:02 AM
#1
Registered User
Thread Starter
Join Date: Mar 2011
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
FS: Ap1 Motor Partout
So i just bought an s2000 and come to find out the motor had two snapped rods, and there was water sitting in the cylinders and head intake chambers. All the other parts on the motor look great, with the exception of the oil pan, 2 rods, and valves.
Location: Cincinnati Ohio
Best way to get ahold of me is by texting me at 513-317-0044. Thanks
Head(with all the internals -cams): 350 shipped
4 Good Coil packs: $100 shipped
Oil Cooler: $50 shipped
Wiring harness: $110 shipped
Intake manifold(complete with throttle body): $140 shipped
Header: $130 shipped
Transmission: $400 picked up
Crank ( Just redone, polished and all, basically brand new): $300 shipped
Flywheel: $60 shipped
clutch fork: $35 shipped
Ap1 ecu: $85 shipped
Ap1 peadals (gas,brake,clutch): $90 shipped
Altenator: $90 shipped
A/C compressor: $90 shipped
Spark Plug Cover: $40 shipped
Belt Tensioner: $40 shipped
Crank pulley: $40 shipped
Aluminum Motor Mounts: $50 shipped(pair)
Thermostat housing: $20 shipped
Anything else that i dont have listed that would have to do with the motor, i probably have, just forgot to post. So let me know if there is something you need thats not listed above, and i will sell the block in pieces if you need the girdle or something like that.
Location: Cincinnati Ohio
Best way to get ahold of me is by texting me at 513-317-0044. Thanks
Head(with all the internals -cams): 350 shipped
4 Good Coil packs: $100 shipped
Oil Cooler: $50 shipped
Wiring harness: $110 shipped
Intake manifold(complete with throttle body): $140 shipped
Header: $130 shipped
Transmission: $400 picked up
Crank ( Just redone, polished and all, basically brand new): $300 shipped
Flywheel: $60 shipped
clutch fork: $35 shipped
Ap1 ecu: $85 shipped
Ap1 peadals (gas,brake,clutch): $90 shipped
Altenator: $90 shipped
A/C compressor: $90 shipped
Spark Plug Cover: $40 shipped
Belt Tensioner: $40 shipped
Crank pulley: $40 shipped
Aluminum Motor Mounts: $50 shipped(pair)
Thermostat housing: $20 shipped
Anything else that i dont have listed that would have to do with the motor, i probably have, just forgot to post. So let me know if there is something you need thats not listed above, and i will sell the block in pieces if you need the girdle or something like that.
