asm rear overfender question
#4
No, rolling is not the same as cutting. With cutting you are increasing the arc size of the fender. If you don't cut the fender and still put a much wider wheel with the over fenders, the tires will still rub on the stock panel.
#6
Registered User
Join Date: Jan 2007
Location: ★HB★
Posts: 2,120
Likes: 0
Received 0 Likes
on
0 Posts
a lot of people roll it and then pull it up or out because they said they might want to go back to stock and remove the over fenders...BUT the rivets holding the over fenders on require you to drill into your rear QP and rolling the QP and pulling it up or out is WAY more difficult to return to stock...etc...just my .02
-Des
btw, i cut about a good 2.75 inches and almost passed out in the process
-Des
btw, i cut about a good 2.75 inches and almost passed out in the process
Trending Topics
#8
Registered User
Join Date: Oct 2005
Location: Houston
Posts: 3,375
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by desmond,Apr 12 2008, 07:53 PM
a lot of people roll it and then pull it up or out because they said they might want to go back to stock and remove the over fenders...BUT the rivets holding the over fenders on require you to drill into your rear QP and rolling the QP and pulling it up or out is WAY more difficult to return to stock...etc...just my .02
-Des
btw, i cut about a good 2.75 inches and almost passed out in the process
-Des
btw, i cut about a good 2.75 inches and almost passed out in the process