24s2k7

I installed my VAFC tonight. Got the harness plugged into the ecu, and the old wiring plugged into the harness. But now I cant fully close up the plastic peice that covers the ecu and hood latch. The wiring from the VAFC Harness is just too bulky. How did you guys do it?

j_c_a

Just keep pushing

24s2k7

Did you get it to fit? Because all the replies from Under The Hood said there is no way to fully push the floor panel in after using the harness!

j_c_a

My kick panel isn't completely flush, no. I've also got a lot of additional electronics wired in behind here so there's no way i could get mine completely back to it's factory location. Sorry if my reply was a bit flipant, i was in a good mood last night

24s2k7

If only there was some way!!!! NOOOOOOOOO!!!!! Now I just need to figure out where to put my vafc

j_c_a

I have mine mounted where the sun visor would normally go. I'm not 100% happy w/ the first pod i made to fit there, so i am currently making another one that molds flush to the roof rail trim. I'm planning to wrap the whole thing in black vinyl so it'll be seemless.