Putting my Invidia back on
06-14-2005, 04:45 PM
#1
Registered User
Thread Starter
Join Date: Jan 2005
Location: Salinas
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
Putting my Invidia back on
To start I took my Invidia exhaust off about a month ago. I thought it was the reason my car had a 6k rpm rattle. To discover it was my heat shield on the exhaust manifold. Anyways my gaskets are all jacked, and I can't find anyone that has them in stock. 
Any recomendations? I was just going to Ultra Copper it back togther, but I figure I better do it right. 
Any recomendations? I was just going to Ultra Copper it back togther, but I figure I better do it right.
06-15-2005, 09:18 AM
#3
Registered User
Join Date: Apr 2002
Location: Mountain View, CA.
Posts: 1,940
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by sebrings2k,Jun 15 2005, 08:03 AM
If you are looking for the gasket that goes between the exhaust and cat. converter any muffler shop should be able to make one.
No leaks so far its been over a year.
06-15-2005, 04:24 PM
#4
Registered User
Thread Starter
Join Date: Jan 2005
Location: Salinas
Posts: 121
Likes: 0
Received 0 Likes
on
0 Posts
Great, thanks for the advice 
. I called Invidia USA, and there official reply was, "we don't carry any replacement parts, only complete systems." Even went as far to call a few other manufacturers. Came to the conclusion that Invidia is one of the few that does NOT use the original "O" ring seal. Thanks again.
. I called Invidia USA, and there official reply was, "we don't carry any replacement parts, only complete systems." Even went as far to call a few other manufacturers. Came to the conclusion that Invidia is one of the few that does NOT use the original "O" ring seal. Thanks again.
Thread
Thread Starter
Forum
Replies
Last Post
lolls
New York - Upstate New York S2000 Owners
1
04-25-2012 03:00 PM