Chris_Lum's Mugen build
#463
Few questions – How hard was it to get the back window in? aaand Where did you get the glass from?
s2 looks so clean.
#464
Thread Starter
it wasn't necessarily hard, just takes patience. Half of the window goes in, then the other half is painstakingly slow as you have to pull the rubber to the right side of the fiberglass. My window is polycarbonate from Mugen.
#465
Community Organizer
#470
Thread Starter
thanks, i am going to hold off on the over fenders for now. I think in a couple of years, if i decide that i'm able to keep my car, then i'll likely do over fenders.
thank you sir
yeah it is 17x9.5 +40 w/ 255 square setup. i am rubbing slightly on the fender liner in the front, but that's about it. -2.8 in the front and -3.4 in the rear.
thank you sir
yeah it is 17x9.5 +40 w/ 255 square setup. i am rubbing slightly on the fender liner in the front, but that's about it. -2.8 in the front and -3.4 in the rear.