Vitaliy is going to be here from April 27th to 30th. We're going to most likely use locash's dynapack.

My car is going to take a good bit of time, but because we're redoing some of it remotely it shouldn't take all day, therefore there's a few open spots if anyone's interested in getting a vit tune.

If you're interested shoot me a PM and I'll send you my phone number to get in contact.


Pricing for Flashpoint not including dyno time
$200 naturally aspirated
$300 forced induction
$100/hr for dyno time.

Average time for a NA flashpro tune is 2 hours.

The charge for a flashpro tune at UMS is $500~

 

Why remote if he is physically there?

 

There's a lot of setup involved with getting all the sensors calibrated, then we're going to do a base gate pressure tune so that it is drivable around town. He can get the idle and everything else down pat remotely so he doesn't have to spend all day on my car and can instead spend 3-4 hours cranking up the boost.

 

So basically I should be looking to spend $400 If I went this route, sweet.

 

I'm in as long as the pricing is the same for a Kpro car with a k24 in it.

 

Might need to budget for dyno time too, not just the tuner. When i did remote tunes that was the case

 

Bumping. If anyone wants in, he flies in tonight and has free time tomorrow and Saturday.

 

Post updates. I'm interested in the results

 

Having some odd issues with the tial gate I have. Going to swap it with another one that I have spare. On Locash's dyno I made 670hp and 500ftlbs of torque @ 24 psi and then started having breakup. I swapped to my other coils and will see where it goes to 28psi.

Oh and at "11-12 psi" or whatever it was at at UMS I was only seeing 400~hp. Goes along with what I was thinking that his dyno reads about 40-50hp high.

 

Looks like I have to replace the diaphragm on my gate. Replaced it with a turbosmart.