Mark this thread as Unsold
WA FS: 2.4L F20C Short Block
#1
WA FS: 2.4L F20C Short Block
DeleteFirst Name: Troy
Price: $5000 USD shipped
Location: Vancouver, Canada/Blaine, WA
Contact: PM
Just completed a 2.4L short block with the CNC Speedshop kit and Wiseco -10cc pistons. I had about 20xxx kilometers on the motor and had the intake cam bolt loosen up on me, causing the engine to seize. Bottom end checked out fine but was re honed, re ringed etc since it was out. Price is including shipping to anywhere in North America.
More info
Rod info-H-beam design
-Rods are designed and rated for high power and high RPM use
-Include custom ARP rod bolts designed specifically to be used with this rod in high RPM, high horsepower & torque setups
Crank Info:
-Brand new OEM K24 crank
-Modifications made to ensure fitment in F20/F22 block
Approximate compression ratios of various pistons setups in conjunction with our kit:
-Stock AP1 - 13:1 Comp
-Stock AP2 - 12:1 Comp
-Wiseco -10cc – 9.9:1 Comp
-Wiseco +7cc – 12.5:1 Comp
-Custom piston specifications – Please contact us for more details
Price: $5000 USD shipped
Location: Vancouver, Canada/Blaine, WA
Contact: PM
Just completed a 2.4L short block with the CNC Speedshop kit and Wiseco -10cc pistons. I had about 20xxx kilometers on the motor and had the intake cam bolt loosen up on me, causing the engine to seize. Bottom end checked out fine but was re honed, re ringed etc since it was out. Price is including shipping to anywhere in North America.
More info
Rod info-H-beam design
-Rods are designed and rated for high power and high RPM use
-Include custom ARP rod bolts designed specifically to be used with this rod in high RPM, high horsepower & torque setups
Crank Info:
-Brand new OEM K24 crank
-Modifications made to ensure fitment in F20/F22 block
Approximate compression ratios of various pistons setups in conjunction with our kit:
-Stock AP1 - 13:1 Comp
-Stock AP2 - 12:1 Comp
-Wiseco -10cc – 9.9:1 Comp
-Wiseco +7cc – 12.5:1 Comp
-Custom piston specifications – Please contact us for more details
Last edited by cheddaboy; 10-07-2020 at 07:43 PM.
#2
So did they rebush the small end on the rod to 23mm to accept the 23mm Wiseco wrist pin or did Wiseco make a custom piston for a 22.98mm oem sized pin? the CNC kit as pictured on the thread was not designed for aftermarket pistons.
#3
It's a wiseco off the shelf piston set. I believe it's the rod that's custom.
Thread
Thread Starter
Forum
Replies
Last Post
helothere
California - Southern California S2000 Owners
4
02-15-2018 08:17 AM