Mark this thread as Sold
Luder's big basement sale...
#1
Luder's big basement sale...
All for S2000
S2000 antenna pending to ScrapDog
Hardtop striker and striker plates (one set) pending to PGA95355
black OEM mirrors pending to ricosuave
a-pillar covers pending to Darius Rucker
S2000 AP1 headlights (new condition, all tabs, factory sealed, no bulbs or ballasts). pending to Darius Rucker
Rear AP1 (MY2000) tail lights pending to Darius Rucker
OEM mirror glass (pair) pending to I dream of S
Muz roof well mat pending to abv
S2000 antenna mast pending to minhdinh85
OEM injectors pending to Holma
coil packs (set of 4, 26k miles) pending to Holma
various intake manifold hoses pending to Holma
EPS fuse box (no fuses, no relay) pending to Squeezer
black smoked orange OEM diffusers SOLD to IceS2000
black radio door cover (full piece with vent trim) SOLD to local buyer
one rear AP1 exhaust tip SOLD to ricky tan
MY2000 Soft top and frame
Black plastic rear shoulder trim (x 3 sets), one set of two trimmed brushes for hardtop (x2)
black vinyl shift boot
exhaust manifold gasket (x2)
center console 2-button trim (goes in place of the coin tray)
OEM bare roll hoops (pair)
exhaust manifold
top header heatshield (x2)(mounts to header)
cat converter (26k miles)
battery tray
OEM front stabilizer bar
OEM rear stabilizer bar
engine bay fuse box heat shield (x2)(black, no holes)
radiator air guide (x2)
black center console glove box with secret compartment cover (with holes for windscreen)
roll hoop covers (separated)
soft top boot plastic (5 pieces; two corner, one rear, one bottom, and one glove box cover)
One full SRS set up (steering wheel and airbag and reel, passenger side (minus cover), seatbelts (pair), SRS computer)
One steering wheel with Rick's "S" circular badge (black lettering on Silver back)
foam tool box tray (no damage)
Intake manifold elbow (OEM)
Rear AP1 (MY2000) tail lights with red lense fade issue
Engine bay fuse box (no fuses, no relays)
cruise control box
OEM black trim corner knee pieces (covers on center tunnel)
soft top control box
ABS control box (ECM)
Rear Body exterior side trim in NFR (pair) (small skinny pieces by trunk lid)
AP1 round hazard button
AP1 Soft top roof switch
plastic battery tray
Rubber roof bumpers (pair)(protects soft top from rubbing against hinge on frame)
Splash guards for front wheels
Dash board bezel (with cruise button)
Audio control (minus start button) (on black silver chrome trim)
HVAC controls (on black silver chrome trim)
NFR exterior door handles
Steering wheel control stalk (windshield control, turn signal control)
Immobilizer trim and circuit pieces (by ignition)
Cruise control steering wheel control box
rear bumper license plate light
lower seat frame (rails, pans, plastic trim, etc.)
oil pan (x2)
rear rotors (pair)
rear upper control arms
rear lower control arms
soft top motors (pair)
rear suframe brace
under hood liner (fire retardant liner, new condition)
foam bumper liners (2 front, 1 rear)
black carpet (transmission tunnel cover)(cut)(giving it away free)
red trunk lid
trunk base cover (cut)
Rick's black and silver leather tunnel cover and shift boot
MY 2000 S2000 radio and 6 disc CD changer with all wiring, cover, and cage
starter
intake manifold
fuel rail
door windows
water pump (x2)
ac pump
alternator
throttle body
windshiled washer tank
coolant overflow tank
tensioner bracket
thermostat housing
air pump
TDC sensors (x2) (the ones that plug into the valve cover)
Polished valve cover
Autozone replacement battery
OEM Honda battery (off of a MY 2004)
S2000 fitment Mugen MF10s (Mugen bronze, no center caps, no lugs)
door sill trim (passenger and drivers)
driver side foot well plastic trim
S2000 antenna
S2000 stubby antenna
Kumho Ecsta 712 (245/40/17 and 215/45/17, fronts have about 15,000-20000 miles on them left, the rears have about 15k miles left, depending on driving style and alignment) Looking to get $200 for this set.
S2000 antenna pending to ScrapDog
Hardtop striker and striker plates (one set) pending to PGA95355
black OEM mirrors pending to ricosuave
a-pillar covers pending to Darius Rucker
S2000 AP1 headlights (new condition, all tabs, factory sealed, no bulbs or ballasts). pending to Darius Rucker
Rear AP1 (MY2000) tail lights pending to Darius Rucker
OEM mirror glass (pair) pending to I dream of S
Muz roof well mat pending to abv
S2000 antenna mast pending to minhdinh85
OEM injectors pending to Holma
coil packs (set of 4, 26k miles) pending to Holma
various intake manifold hoses pending to Holma
EPS fuse box (no fuses, no relay) pending to Squeezer
black smoked orange OEM diffusers SOLD to IceS2000
black radio door cover (full piece with vent trim) SOLD to local buyer
one rear AP1 exhaust tip SOLD to ricky tan
MY2000 Soft top and frame
Black plastic rear shoulder trim (x 3 sets), one set of two trimmed brushes for hardtop (x2)
black vinyl shift boot
exhaust manifold gasket (x2)
center console 2-button trim (goes in place of the coin tray)
OEM bare roll hoops (pair)
exhaust manifold
top header heatshield (x2)(mounts to header)
cat converter (26k miles)
battery tray
OEM front stabilizer bar
OEM rear stabilizer bar
engine bay fuse box heat shield (x2)(black, no holes)
radiator air guide (x2)
black center console glove box with secret compartment cover (with holes for windscreen)
roll hoop covers (separated)
soft top boot plastic (5 pieces; two corner, one rear, one bottom, and one glove box cover)
One full SRS set up (steering wheel and airbag and reel, passenger side (minus cover), seatbelts (pair), SRS computer)
One steering wheel with Rick's "S" circular badge (black lettering on Silver back)
foam tool box tray (no damage)
Intake manifold elbow (OEM)
Rear AP1 (MY2000) tail lights with red lense fade issue
Engine bay fuse box (no fuses, no relays)
cruise control box
OEM black trim corner knee pieces (covers on center tunnel)
soft top control box
ABS control box (ECM)
Rear Body exterior side trim in NFR (pair) (small skinny pieces by trunk lid)
AP1 round hazard button
AP1 Soft top roof switch
plastic battery tray
Rubber roof bumpers (pair)(protects soft top from rubbing against hinge on frame)
Splash guards for front wheels
Dash board bezel (with cruise button)
Audio control (minus start button) (on black silver chrome trim)
HVAC controls (on black silver chrome trim)
NFR exterior door handles
Steering wheel control stalk (windshield control, turn signal control)
Immobilizer trim and circuit pieces (by ignition)
Cruise control steering wheel control box
rear bumper license plate light
lower seat frame (rails, pans, plastic trim, etc.)
oil pan (x2)
rear rotors (pair)
rear upper control arms
rear lower control arms
soft top motors (pair)
rear suframe brace
under hood liner (fire retardant liner, new condition)
foam bumper liners (2 front, 1 rear)
black carpet (transmission tunnel cover)(cut)(giving it away free)
red trunk lid
trunk base cover (cut)
Rick's black and silver leather tunnel cover and shift boot
MY 2000 S2000 radio and 6 disc CD changer with all wiring, cover, and cage
starter
intake manifold
fuel rail
door windows
water pump (x2)
ac pump
alternator
throttle body
windshiled washer tank
coolant overflow tank
tensioner bracket
thermostat housing
air pump
TDC sensors (x2) (the ones that plug into the valve cover)
Polished valve cover
Autozone replacement battery
OEM Honda battery (off of a MY 2004)
S2000 fitment Mugen MF10s (Mugen bronze, no center caps, no lugs)
door sill trim (passenger and drivers)
driver side foot well plastic trim
S2000 antenna
S2000 stubby antenna
Kumho Ecsta 712 (245/40/17 and 215/45/17, fronts have about 15,000-20000 miles on them left, the rears have about 15k miles left, depending on driving style and alignment) Looking to get $200 for this set.
Trending Topics
#10
I have a whole list of PM's to go through. Everyone should expect to have a reply by tomorrow.
As for prices, I didn't post any because it was too daunting of a task to look up and then put up an asking price for each part.
Here's a suggestion, look up the part you are interested in on my list at http://www.hondaautomotiveparts.com
Find the discounted retail price on their site, and then offer me something reasonable from that. Locals and others that have bought from me in the past know that I give GREAT deals on stuff like this (the Mugen MF10's, on the other hand, will go for full market value....whatever that may be).
As for prices, I didn't post any because it was too daunting of a task to look up and then put up an asking price for each part.
Here's a suggestion, look up the part you are interested in on my list at http://www.hondaautomotiveparts.com
Find the discounted retail price on their site, and then offer me something reasonable from that. Locals and others that have bought from me in the past know that I give GREAT deals on stuff like this (the Mugen MF10's, on the other hand, will go for full market value....whatever that may be).