Mark this thread as Sold
long block part out
#1
long block part out
EVERYTHING IS PLUS SHIPPING AND PAYPAL FEE
PREFER PICK UP ON BLOCK AND HEAD BUT MIGHT BE ABLE TO WORK OUT SHIPPING
LOCATED IN LINDEN NJ 07036
WILL SEPERATE EVERYTHING MAKE OFFERS!!
- crank soldd
- rods soldd
- headgasket solddd
- oil pumpp soldddd
- water pump and housing
- ap1 head $150 + shipping. could use rebuild pm for details
- ap1 cams $120 shipped
- ap1 rockers $ 150 +shipping
- vtec solenoid $50 shipped
- valve cover with spark plug cover with new gaskets $150 + shipping
- ap1 block with main caps and oil squirters eliminated and notched for 2.4 crank. over sized bore and scored a little .. good for sleeves $150+ shipping..
- oil pan $80
- f20c crank. no spun bearings $150 + shipping
- new arp head studs, never torqued $100
- starter painted black $50 shipped
- alternator painted black $50 shipped
- ap1 engine harness $115 shipped
- ap1 ecu with immobilizer removed $50 shipped (never drove with it but starts car)
- ap1 firewall harness with fuse box $60 shipped
[B]
PREFER PICK UP ON BLOCK AND HEAD BUT MIGHT BE ABLE TO WORK OUT SHIPPING
LOCATED IN LINDEN NJ 07036
WILL SEPERATE EVERYTHING MAKE OFFERS!!
- crank soldd
- rods soldd
- headgasket solddd
- oil pumpp soldddd
- water pump and housing
- ap1 head $150 + shipping. could use rebuild pm for details
- ap1 cams $120 shipped
- ap1 rockers $ 150 +shipping
- vtec solenoid $50 shipped
- valve cover with spark plug cover with new gaskets $150 + shipping
- ap1 block with main caps and oil squirters eliminated and notched for 2.4 crank. over sized bore and scored a little .. good for sleeves $150+ shipping..
- oil pan $80
- f20c crank. no spun bearings $150 + shipping
- new arp head studs, never torqued $100
- starter painted black $50 shipped
- alternator painted black $50 shipped
- ap1 engine harness $115 shipped
- ap1 ecu with immobilizer removed $50 shipped (never drove with it but starts car)
- ap1 firewall harness with fuse box $60 shipped
[B]
#7
they the same and accord crank.. bore is 87.5mm. and no the motor never ran the machine shop ****ed up the bore. they didn't bore it out enough and the pistons got scored and the walls a little but if you get it honed it should be the right size and the scratches will come out cause they are not deep at all.