Official thread reserved for "ASM'ed" S2000
#1611
Finally get to post in this thread!
ASM Duckbill courtesy of Felipe off the ASM Demo Car.
Haven't decided if I even want to repaint it to match my car since it is off of Felipe's epic build.
ASM Duckbill courtesy of Felipe off the ASM Demo Car.
Haven't decided if I even want to repaint it to match my car since it is off of Felipe's epic build.
#1614
any of you guys find a third brakelight solution when installing your duckbill spoiler? debating whether to cut mine up to add one (rather not) or add an LED strip to the rear decklid area.
#1616
^^^ nice, but still on the fence about a rollbar because i don't really want to hack up my rear panels.
i came across a site that sells all kinds of third brakelights. i'll see if they have any that won't stick out like a sore thumb. otherwise, i'm going to use an LED strip near the windscreen mount.
on a sidenote, i mounted my duckbill. looks pretty good. i think i might get a GT wing too when i find a spare trunk. here's a quick cell pic i just took. sorry, car is dirty. been travelling the last couple months and slammed with work too.
i came across a site that sells all kinds of third brakelights. i'll see if they have any that won't stick out like a sore thumb. otherwise, i'm going to use an LED strip near the windscreen mount.
on a sidenote, i mounted my duckbill. looks pretty good. i think i might get a GT wing too when i find a spare trunk. here's a quick cell pic i just took. sorry, car is dirty. been travelling the last couple months and slammed with work too.
#1617
Community Organizer
gl! just make sure it's high enough to see when top is up.
if you run the mugen cage cover you only need to remove oem roll hoops, remove center console top cover and trim the tray under that
here's a pic from my03 for reference:
and with asm bolts securing cover later:
if you run the mugen cage cover you only need to remove oem roll hoops, remove center console top cover and trim the tray under that
here's a pic from my03 for reference:
and with asm bolts securing cover later:
#1619
anyway, i'll definitely test the placement of the LED brakelight before mounting it. gonna be tricky because it does need to bee high enough to be seen, top up or down. was thinking of the rear decklid area, near the top moulding or where the seam where the trunk meets the panel w/the moulding, but i might be a problem if i get a hardtop. i still don't get why ASM or anyone else hasn't made a decklid spoiler w/a brakelight. closest thing is the Tamon, but i don't really like the lines on it.